Product added to your wishlist! View wishlist
Sign in to see your saved products on any device
Product removed from your wishlist! View wishlist
Sign in to see your saved products on any device
Something went wrong. Please try again later.
Product is added to compare already. Please refresh the page.
Product is not found in compare. Please refresh the page.
5 Products already added. Please delete existing selection to add this.
Share this product
16 Channel PWM Servo Motor Controller DIY for Arduino
This product ad may change over time
Share16 Channel PWM Servo Motor Controller DIY for Arduino
1. Works with official Arduino boards 2. This is an I2C controlled PWM driver board with a built-in clock 3. You can use 3.3V MCU to control and drive the output up to 6V 4. 6 address select pins allow you to connect 62 driver boards to one I2C bus, total 992 channels of PWM output 5. About 1.6KHz frequency modulation PWM output 6. PCA9685 chi…
1. Works with official Arduino boards 2. This is an I2C controlled PWM driver board with a built-in clock 3. You can use 3.3V MCU to control and drive the output up to 6V 4. 6 address select pins allow you to connect 62 driver boards to one I2C bus, total 992 channels of PWM output 5. About 1.6KHz frequency modulation PWM output 6. PCA9685 chip is at the center of the board 7. With power input terminal 8. With green power indicator light 9. Convenient to insert total 16 servos at the same time 10. With reverse polarity protection for input 11. Cascade design 12. Put a bulky capacitor on the V+ line 13. Put 220 ohm resistance components onto all PWM output lines Specification: General Size 6.2*2.6*1.2cm Weight 10g Package Weight One Package Weight 0.04kgs / 0.08lb Qty per Carton 120 Carton Weight 4.20kgs / 9.26lb Carton Size 34cm * 27cm * 22cm / 13.39inch * 10.63inch * 8.66inch
Description
1. Works with official Arduino boards 2. This is an I2C controlled PWM driver board with a built-in clock 3. You can use 3.3V MCU to control and drive the output up to 6V 4. 6 address select pins allow you to connect 62 driver boards to one I2C bus, total 992 channels of PWM output 5. About 1.6KHz frequency modulation PWM output 6. PCA9685 chip is at the center of the board 7. With power input terminal 8. With green power indicator light 9. Convenient to insert total 16 servos at the same time 10. With reverse polarity protection for input 11. Cascade design 12. Put a bulky capacitor on the V+ line 13. Put 220 ohm resistance components onto all PWM output lines Specification: General Size 6.2*2.6*1.2cm Weight 10g Package Weight One Package Weight 0.04kgs / 0.08lb Qty per Carton 120 Carton Weight 4.20kgs / 9.26lb Carton Size 34cm * 27cm * 22cm / 13.39inch * 10.63inch * 8.66inch
Specifications
| Brand | Diy |
| Number Of Channels | 16 |
| Compatible Devices | Arduino |